• Deutsch
  • English

Scratches in Effect Surface

Step: 

Remove all loose particles. Clean surface. Use the rounded side of the Edge Planer to press the damaged edges down – in the direction of the grain.

Products required: 

Choose several colour shades that correspond to the surface.

Products required: 

Hold Effect Wax sticks in turn to the hot tip of the Hot Knife. Important: Do not set temperature of the heater too high.

Let colour wax mixture flow into the damaged area.

Due to the transparency of the Effect Wax, areas of larger damage require filling with Hard Wax first. The damage has to be filled with Hard Wax first and, finally, to obtain a reflective capacity, Effect Wax is added to the upper layer.

Remove surplus wax with the Special Fillers Applicator.

Products required: 

Make an intermediate sealing by misting with Special Repair Lacquer Plus from a distance of 30-40 cm – do not spray too wet. Use the Graining Pen to replicate grain pattern.

Seal the filled damage by misting with Special Repair Lacquer Plus or Furniture Lacquer Plus from a distance of 30-40 cm - a fine mist coat is all that is needed, do not apply a wet coat.

Products required: