• Deutsch
  • English

Pressure Marks

Step: 

Clean surface.

Products required: 

Compress damaged edges using the round side of the Edge Planer.

Products required: 

Fill pressure marks by means of transparent Hard Wax and the Hot Knife. Using the Blade of the Electric Heater improves spreading of the wax without creating a too high projecting. Remove surplus wax with the Special Fillers Applicator. Note: Sharp grooves on the flat surface, round grooves at edges.

Seal filled damage by misting with Special Repair Lacquer PLUS from a distance of 30-40 cm - do not spray too wet.

Products required: