• Deutsch
  • English

Hole in Polyester Surface

Step: 

Remove all loose particles. Cut edges at an angle and slightly sand with 800 grit Sandpaper. Clean surface. Light-appearing spots should be pre-dyed with Touch-Up Dye.

Dip wooden spatula into the mixed lacquer and ‘dab’ drops into the damage area. In case of a large damage, just pour lacquer directly out of the cup. Generously overfill the damage area – the matt paraffin coat which develops must not be touched. Hardening time at least 60 minutes. If lacquer has been dyed, a curing time of 12-24 hours is recommended, this also applies to repairs to piano parts.

Gently strip off polyester using the Special Scraper or the Metal Planer. For detailed information on how to mix lacquer, please see instructions for use.

Products required: 

Sand surface using Sanding Liquid, Sandpaper and Micro Sanding Paper, beginning with the lowest grit. Clean surface after every sanding process.

Apply Polishing Paste 'fine' to the Felt Pad and polish off fine sanding dullness. Use sufficient Polishing Paste - do not allow paste to dry during polishing process as lumps may develop and cause abrasions. Now and then wipe with a Special Cloth to check result.

Products required: