• Deutsch
  • English

Drill Hole in a Tile

Step: 

Preparation: The damage area has to be clean, dry and free from grease.

Products required: 

Filling: Use the hot tip of the Hot Knife to apply Ceramic Filler of the matching shade to the damaged area. Always work from light to dark. To match the right shade, different colours can be intermixed. Clean the tip of the heating iron after use.

Products required: 

Levelling: Use the Transparent Special Fillers Applicator to strip off excess material. Important: Do not use a metallic tool, as this would create metal abrasion and the filled area would turn dark.

Products required: 

Colour corrections can be made by repeating the previous stage (with the desired colour) and again removing any surplus using the Special Fillers Applicator. With even and high-gloss surfaces, fill small pores with transparent filler and again remove excess material with the Special Fillers Applicator.

Cleaning: Clean the area with a cloth and Eco Cleaner.

Products required: 

Seal the dry, repaired area with the Brush Pen Clear Lacquer (high-gloss or matt finish). The only exception is for white high-gloss surfaces. These should be sealed with the relevant highgloss Brush Pen Covering Lacquer (colours can be intermixed).

Gloss Sheen Adjustment: When the sealed area is dry (after approx. 4 hours at room temperature) a final gloss sheen adjustment can be made with the Sanding & Polishing Cloth. The white side of the cloth reduces the sheen level while the green side polishes.

Products required: