• Deutsch
  • English

Damaged Edges - Example 2

Step: 

Remove all loose particles. Clean surface.

Products required: 

Cut damage edges straight down with the Edge Planer.

Products required: 

Pre-colour damage in the substrate with Covering Lacquer Brush Pen corresponding to the surrounding area.

Products required: 

Choose several colour shades of Hard Wax PLUS corresponding to the surface and hold wax sticks in turns to the hot tip of the Electric Heater. Let colour wax mixture flow into the damage in the direction of the grain.

Products required: 

Remove surplus wax with the Special Fillers Applicator. Note: Sharp grooves on the flat area Rounded grooves at edges.

Products required: 

Make an intermediate sealing by misting with Special Repair Lacquer PLUS from a distance of 30-40 cm – do not spray too wet. Restore the grain with the Touch-Up Paint Box and the Red Marten Brush.

Seal filled damage by misting with Special Repair Lacquer PLUS from a distance of 30-40 cm – do not spray too wet.

Products required: